Giulia Tipo 952

Clip-on cover that blocks the light gap around the sun-visor retaining point while preserving normal visor operation. The creator explicitly identifies 2018-and-later Alfa Romeo Giulia and Stelvio fitment and recommends PETG, ABS or ASA for summer cabin heat.

Clip-on shield for the original forward-collision radar cover to reduce water, dirt and snow accumulation. The creator explicitly states Alfa Romeo Stelvio and Giulia fitment and reports testing at all sensitivity settings without affecting operation. Remove it immediately if any radar or driver-assistance warning appears.

Console-mounted phone holder sized for an iPhone 12 Mini with a protective case. The creator explicitly states Alfa Romeo Stelvio and Giulia fitment and recommends PETG or ABS because cabin heat can deform PLA. Confirm device clearance and secure retention before driving.

Printable repair and alignment jig for rebuilding broken left- or right-side fog-lamp mounting tabs. The creator identifies Giulia and Stelvio fitment and calls for two-part structural plastic adhesive. This is an alignment aid, not a printable lamp or lens.

Replacement cover for a lost or broken ISOFIX access-opening flap on 2018-and-later Giulia and Stelvio rear seats. This is non-structural trim and must not obstruct the child-seat anchor.

Replacement passenger-side trim cover around the seat-adjustment controls. The creator explicitly identifies Giulia and Stelvio fitment; verify switch clearance before use.

Longer and less bulky interior-mirror attachment variant for the creator’s Giulia phone-mount system, providing additional adjustment range.

Adapter for mounting a Sony Xperia Z5 Compact at the interior-mirror location. It is the phone-side companion to the creator’s Giulia mirror attachment.

Replacement actuator finger for the glovebox latch. The creator made it for a Giulia Quadrifoglio after the original plastic actuator failed. Check latch release and retention before closing the glovebox.

Adjustable phone holder designed and measured on a 2018 vehicle, with 13 mm and 16 mm frame variants. The creator recommends PETG after a PLA version deformed in a hot parked car.

Two-piece folding grocery holder designed by Carlos Solis for the Giulia trunk. It bolts to the factory mounting location, folds out of the way, and the creator printed it in PETG for heat resistance.

Adapter at the interior-mirror location for a Sony Xperia Z5 Compact phone, as identified by the creator.