Alfa Romeo Stelvio

Replacement forward-collision radar cover with thicker clips and extended coverage intended to reduce water, snow and dirt accumulation. The creator test-fitted it on a late-2018 vehicle. Remove it immediately if any radar or driver-assistance warning appears.

Clip-on cover that blocks the light gap around the sun-visor retaining point while preserving normal visor operation. The creator explicitly identifies 2018-and-later Alfa Romeo Giulia and Stelvio fitment and recommends PETG, ABS or ASA for summer cabin heat.

Cap for the opening in the sun visor. The source explicitly identifies Alfa Romeo Stelvio fitment. Compare the opening and clip geometry before installation and use a cabin-heat-resistant material.

Clip-on shield for the original forward-collision radar cover to reduce water, dirt and snow accumulation. The creator explicitly states Alfa Romeo Stelvio and Giulia fitment and reports testing at all sensitivity settings without affecting operation. Remove it immediately if any radar or driver-assistance warning appears.

Replacement left and right deflectors fitted ahead of the rear wheels, with an optional reinforcement pad for a flexible print. The creator reports months of use. Print the deflectors in TPU for flexibility and the reinforcement pad in a stiff weather-resistant material; verify wheel, tyre, suspension and fastener clearance before use.

Snap-on door-hinge cover designed and test-fitted on a 2018 vehicle. It fits without adhesive according to the creator. Use PETG or another cabin/exterior-heat-resistant material and confirm the cover does not interfere with hinge travel.

Console-mounted phone holder sized for an iPhone 12 Mini with a protective case. The creator explicitly states Alfa Romeo Stelvio and Giulia fitment and recommends PETG or ABS because cabin heat can deform PLA. Confirm device clearance and secure retention before driving.

Printable repair and alignment jig for rebuilding broken left- or right-side fog-lamp mounting tabs. The creator identifies Giulia and Stelvio fitment and calls for two-part structural plastic adhesive. This is an alignment aid, not a printable lamp or lens.

Replacement cover for a lost or broken ISOFIX access-opening flap on 2018-and-later Giulia and Stelvio rear seats. This is non-structural trim and must not obstruct the child-seat anchor.

Replacement passenger-side trim cover around the seat-adjustment controls. The creator explicitly identifies Giulia and Stelvio fitment; verify switch clearance before use.

Two center-armrest storage tray variants: plain and with coin compartments. The creator recommends adding double-sided rubber inside to stop objects sliding.

Lower movable mounting bracket for an Alfa Romeo Stelvio headlight, designed as an alternative to the complete headlamp repair kit.

Replacement cover for the forward-collision-warning radar sensor. The creator notes that the original is easily lost and that snow or ice accumulation can make the radar sensor inoperative.