Alfa Romeo Giulietta

Alternative M6 and M4 adapters for fitting an aftermarket threaded shift knob to the standard shift rod. Use the M6 variant with an intact original thread; the M4 variant requires drilling and tapping a damaged rod. Confirm secure retention, full gear selection and no reverse-lockout interference before driving.

Three attachment joints for bonding inside a right-side aftermarket mirror cap. The creator specifies Alfa Romeo Giulietta fitment and epoxy adhesive. Right side only; dry-fit every joint, prepare bonding surfaces correctly, and verify the cap remains secure.

Replacement retainer for the 90-degree end of a broken interior door-release cable. The creator redesigned and installed it in a Giulietta door mechanism. Use a tough material and verify reliable repeated release from inside and outside before returning the vehicle to service.

Storage shelf fitted ahead of the gear lever above the DNA selector area on 2013-on vehicles. The creator shows it installed and reports printing without supports with adequate cooling. Keep the selector and adjacent controls fully accessible.

Left- and right-side spacers that provide clearance for protruding LED high-beam cooling hardware while retaining the original rear headlamp covers. The creator requires silicone sealing. Use heat- and weather-resistant material and verify both covers remain secure and watertight after installation.

Press-fit holder for a slim beverage can in the center console. The creator designed and physically fit-tested it in a 2018 vehicle. Confirm stable retention and keep the container clear of the handbrake and controls.

Reinforced replacement for a weak interior pull handle reverse-engineered from the original component. Use a tough, heat-resistant material, compare the mounting points with the original, and verify the handle is securely retained before use.

Replacement clip for a broken hinge pin on the dashboard storage-bin lid. The creator specifies 0.2 mm layers, 100% infill, side orientation and supports.