Exterior

Extended two-piece version of the MiTo cabin-air intake water deflector, comprising the main deflector and flange. It provides more coverage than the ancestor and retains the original warning that seams may need adhesive sealing. Both validated 3MF pieces are required. PETG follows the tested material rationale of the underlying water-deflector design.

Scuttle-area deflector that redirects water away from the cabin-air intake when an aged windscreen/scuttle seal channels rain toward the vent. The creator used PETG and also sealed the joints with glue. It is an auxiliary deflector, not a substitute for repairing the drain or weather seal.

Tapón para deposito de agua limpiaparabrisas alfa romeo 147 JTD

Simple winter cover that shields Alfa Romeo 156 windscreen-washer nozzles from snow. ABS is inferred for exterior cold, weather and sun exposure; PETG is an alternative.

One-millimetre shorter-arm remix of the windscreen washer-nozzle clip for a Tipo 916 GTV wiper assembly. The creator states that the original geometry did not retain the sprayer securely on their GTV and shortened the secondary arm by 1 mm; use this variant only when the source clip is loose and compare against the original before fitting.

Replacement clamp for securing the triangular washer pipe to the windscreen-wiper assembly. The creator printed and test-fitted it on a Tipo 916 GTV 2.0 V6 and recommends ABS for resistance to sun and weather; compare the original clamp and hose routing before installation.

Protective cover for the windscreen-wiper arm retaining nut on a Type 116 GTV6. Confirm nut clearance and secure engagement before driving.

Two source-provided clip geometries for retaining the windscreen-washer nozzles and hose on Tipo 916 Spider and GTV wiper assemblies. Compare the original clip location and hose routing, then select the matching source variant before installation.

Replacement flexible cap fitted between the windscreen-wiper arm and retaining nut on 1970s Alfa Romeo Tipo 115 Spiders. Check pivot clearance and secure wiper-arm retention before use.

Two-piece replacement filler spout and cap designed by Giuseppe Portelli for the windscreen-washer reservoir of a 147. The creator printed it in PETG, glued the spout to the tank with cyanoacrylate, and provides an editable Fusion 360 source for tuning the attachment diameter.

Replacement headlamp-washer jet nozzles for the 155, created because the originals deteriorate in sunlight. The source supplies the standard nozzle and a spray variant.